map-of-flight Kiss V2 32bits

The card flying KISS V2 is a best seller created by flyduino for the most demanding pilot.

Tested intensively, its code has been optimized to the highest point.

It is possible to download presets of the known drivers to get the same configuration.

And of course, you can adjust the PID you-even through the graphical interface.

Technical characteristics:

• MCU: STM32F722RET6 @ 216 MHz
• IMU: MPU6000
• Mass: 5g
• Mounting: 3x3cm
• Voltage: 2-6S (direct lipo)
• Tri, the Y4 and Y6 * Quad + / x * Hexa + / x
• The required USB driver will be installed when you connect the FC the first time. This may take several minutes before you can bind the FC to the gui.
• Support for FrSky Sbus, Graupner SumD, GER CROSSFIRE and Multiplex SRXL S-Port, HOTT, GER CROSSFIRE and Sensorbus.
• Turtle Mode supported
• 5x serial ports
• RunCam Split supported
• RGB Led supported
• DShot 2400
• FW via a graphical user interface
• Adaptive filter advanced
• Available advanced engine
• Windows, OSX, Android supported