Sapphire 2.90m PNP Robbe Motor Glider

The SAPPHIRE is the new thermal and versatile glider from Robbe Modellsport. The V-tail increases its maneuverability during thermal circles. The PNP version has servos already mounted, an electrical connection and original Multilocks as wing safety.
Flight characteristics can be called very docile. The SAPPHIRE can be used as a slow thermal glider or as a multipurpose glider, even if it is a little faster.
The interlined wings are composed of a polystyrene core, layers of glass fibers, an Abachi coating and a carbon fiber reinforced spar. The weight/strength ratio has been obtained optimally.

The SAPPHIRE is intended for advanced model pilots.

Feature:
The wing is designed to be used in extreme conditions.
- two-part wing, covered with Oracover, in Styro/GfK/Abachi, with CfK connectors
- continuous sandwich spar (carbon-pin-carbon) for maximum flexural strength
- Integrated Robbe FS-277 digital servos with ball bearings and metal gears (PNP version only)
- Wiring of all servos with 6-pole MPX connectors between the wing and the fuselage (PNP version only)
- ironed rudder flaps with mounted rudder horns
- Painted fiberglass fuselage with wooden frames and integrated fiberglass reinforcements
- powerful Ro-Power Torque 3526-870 K/V outer rotor, optimized for 4S (PNP version only)
- large glass roof for easy battery change
- control flaps already mounted on hinges
- prefabricated control rods with German-made articulation parts
- servo and linkage well covers already cut out
- 38mm anodized aluminum spinner with straight center part (PNP version only)
- very resistant 13x7" carbon fiber propeller (PNP version only)
- modern and well visible design

Technical characteristics:

- Wingspan: 2900mm

- Weight: 2480g

- Length: 1290mm

- Glass/carbon fuselage

- Wing: Styro/Fiberglass/Abachi

Product content:

- Sapphire model almost ready to fly, prefabricated
- Painted fiberglass/carbon fuselage with integrated Ro-Power Torque 3526-870 motor and two Robbe FS-277 servos
- Styro/fiberglass/Abachi webbed wing with four integrated Robbe FS-277 servos
- balsa V-tail, lined with Oracover and removable
- Male/female MPX jack already installed
- MULTIlock already installed
- Servo extension cable already installed
- 38mm aluminum cone and 13x7" CfK propeller.
- Small parts (bells, linkages, screeds, covers, etc.), but already mounted
- Assembly instructions in German/English/French